iCommand-Touch Manual

CAP-837
2.7.4.9
"Lock Display" screen
Fig. 39: "Lock Display" screen
2.7.5
"Configuration" menu
Overview
Fig. 40: Configuration screen
"Communication" screen
Fig. 41: "Communication" screen
iCommand
37
"Lock Display" screen
This function is used to clean the display without accidental triggering
operation. After this function has been started, the control cannot be
used for one minute.
This
function is available regardless of code level.
"Configuration" menu
This menu contains the following submenus:
 Communication ( Chapter 0 ‘
"Communication" screen
page 44)
 MK200 modules ( Chapter 2.7.5.1 ‘
"MK200 modules" screen
page 45)
 Inputs / Outputs ( Chapter 2.7.5.2 ‘
"Inputs / Outputs" screen
page 46)
 Heating / ventilation ( Chapter 4.7.6.4 ‘ "
Heating / ventilation"
screen’ on page 46)
 Compressor type ( Chapter 2.7.5.3 ‘
"Compressor type" screen
on page 48)
This screen shows the settings for the communication.
iCommand – Touch
iCommand
- Touch
This function is used to clean the display without accidental triggering
operation. After this function has been started, the control cannot be
function is available regardless of code level.
"Communication" screen
’ on
"MK200 modules" screen
’ on
"Inputs / Outputs" screen
’ on
Heating / ventilation"
"Compressor type" screen
’
This screen shows the settings for the communication.