iCommand-Touch Manual

CAP-837
Fig. 27
: "Switching times compr." screen
for Channel 1
2.7.4.3
"Pressure times compr." screen
Fig. 28
: "Pressure times compr." screen
(start page)
Fig. 29
: "Pressure times compr." screen
for Channel 1
iCommand
31
: "Switching times compr." screen
In the displayed example (Fig. 27
) the compressor would operate at
least from Monday to Friday from 1 pm to 10:30 pm. To switch the
compressor on for one or several days continuously, the respective
days must be selected and 00:00 must be entered for switching time
"Pressure times compr." screen
: "Pressure times compr." screen
The timer can be activated and deactivated. The compressor operates
at the programmed time with the respectively set pressure range, if
the "Pressure times compr." is set to "On". There are 8 Switching
times available for programming. The pressure range of
channel, which has a current valid time programmed always applies.
The compressor moves to the pressure range set in the "Control"
menu, if the "Switching times compr." is set to "Off". It is also possible
to switch individual channels on
or off. The timer will not be consi
ered during the analysis, if a programmed channel is set to "Inactive".
The set times and pressures however stay and can be activated if
needed.
: "Pressure times compr." screen
In the example (Fig. 29
) shown, the pressure range
was set to 123
–
9.5 bar on the weekend between 10:15 am and 10:30
pm.
To switch on a pressure range for the compressor on for one or se
eral days continuously
, the respective days must be selected and
00:00 must be entered for switching times.
iCommand – Touch
iCommand
- Touch
) the compressor would operate at
least from Monday to Friday from 1 pm to 10:30 pm. To switch the
compressor on for one or several days continuously, the respective
days must be selected and 00:00 must be entered for switching time
s.
The timer can be activated and deactivated. The compressor operates
at the programmed time with the respectively set pressure range, if
the "Pressure times compr." is set to "On". There are 8 Switching
times available for programming. The pressure range of
the first active
channel, which has a current valid time programmed always applies.
The compressor moves to the pressure range set in the "Control"
menu, if the "Switching times compr." is set to "Off". It is also possible
or off. The timer will not be consi
d-
ered during the analysis, if a programmed channel is set to "Inactive".
The set times and pressures however stay and can be activated if
) shown, the pressure range
of the compressor
9.5 bar on the weekend between 10:15 am and 10:30
To switch on a pressure range for the compressor on for one or se
v-
, the respective days must be selected and