iCommand-Touch Manual

CAP-837
2.7.2
"Operating parameters" menu
This menu contains the following parameters:
Parameter
Value setting/Initial setting/Remarks
Automatic
restart
Automatic restart after power failure.
Setting range: Yes/No
Initial setting: No
Remote
On/Off
Specifies the possibility to switch the system on or off remotely. If yes,
switching on and off can be done via a digital input. If no, a
programmed digital input will be ignored.
Setting range: Yes/No
Initial setting: No
Remote
Load / Idling
Specifies the possibility to trigger an external load request via a digital input.
If yes, switching on and off can be done
tively programmed digital input will be ignored. On a LLC slave it is thereby
specified as if the input signal
Setting range: Yes/No
Initial setting: No
Circulation
Activate/deactivate the circulation for
culation start/stop depends on the temperature limits found in the heating /
ventilation menu.
Setting range: Yes/No
Initial setting: No
Operating
mode
Selection of the operating mode Specifies the behavi
During Off-/On-
load the motor runs continuously, during automatic oper
tion the motor will be completely stopped (while considering the required
stopping time), if the load requirement is missing.
Setting range: Automatic/On-
load/Off
Initial setting: Automatic
Switch. cy-
cles moni-
tored
Activating or deactivating the switch cycles monitoring.
Setting range: Yes/No
Initial setting: No
iCommand
26
"Operating parameters" menu
This menu contains the following parameters:
Value setting/Initial setting/Remarks
Co
pressor
type
Automatic restart after power failure.
All
Specifies the possibility to switch the system on or off remotely. If yes,
switching on and off can be done via a digital input. If no, a
respectively
programmed digital input will be ignored.
All
Specifies the possibility to trigger an external load request via a digital input.
If yes, switching on and off can be done
via a digital input. If no, a respec-
tively programmed digital input will be ignored. On a LLC slave it is thereby
specified as if the input signal
All
Activate/deactivate the circulation for
anti-freeze protection. The actual cir-
culation start/stop depends on the temperature limits found in the heating /
All
Selection of the operating mode Specifies the behavi
or during load change.
load the motor runs continuously, during automatic oper
a-
tion the motor will be completely stopped (while considering the required
stopping time), if the load requirement is missing.
load/Off
-load
All
Activating or deactivating the switch cycles monitoring.
All
iCommand – Touch
iCommand
- Touch
Co
m-
pressor
type
State
All
Editable
All
Editable
All
Editable
All
Editable
All
Editable
All
Editable