iCommand-Touch Manual

CAP-837
2.3
Operating modes
Overview
Three operating modes can be set using the controller.
Operating mode
Automatic operation
Load/idle operation
Lead lag control mode
(LLC operation)
Safety pressure
The safety pressure is the sum of the set maximum pressure +
PSI
. If the pressure exceeds the value of the safety pressure, the
compressor is switched off with a fault message. If the maximum
pressure is
iCommand
12
Operating modes
Three operating modes can be set using the controller.
Operating mode
Description
Automatic operation
After reaching the switch
-
the system switches to idle for
duration of the idle time (run
the run-
on time has elapsed, the m
tor switches off. The compressor can
start up by itself at any time if the m
chine drops below the switch
sure.
Load/idle operation
The compressor switches between
"Load" and "Idle" operation; i.e. there
is an unlimited run-on.
Lead lag control mode
(LLC operation)
The switch on/off pressure set is not
taken into account by the controller.
The compre
ssor is controlled by a
master controller.
The safety pressure is the sum of the set maximum pressure +
. If the pressure exceeds the value of the safety pressure, the
compressor is switched off with a fault message. If the maximum
pressure is
exceeded by 7 PSI
, a warning appears on the display.
iCommand – Touch
iCommand
- Touch
-
off pressure,
the system switches to idle for
the
duration of the idle time (run
-on). After
on time has elapsed, the m
o-
tor switches off. The compressor can
start up by itself at any time if the m
a-
chine drops below the switch
-on pres-
The compressor switches between
"Load" and "Idle" operation; i.e. there
The switch on/off pressure set is not
taken into account by the controller.
ssor is controlled by a
The safety pressure is the sum of the set maximum pressure +
14
. If the pressure exceeds the value of the safety pressure, the
compressor is switched off with a fault message. If the maximum
, a warning appears on the display.