iCommand Manual

CAP-836
Fault
no.
Fault
abbreviation
Cause of the fault
81 FC
Frequency converter fault
82 diF P
Differential pressure fine
precipitator too high
89 modul
Fault of EA module (reports
a failure or does not
respond)
90 dP Mi
Dew point temperature too
low
91 dP MA
Dew point temperature too
high
2.8.2
Warning/maintenance messages
Fig. 10
: Warning/maintenance message
iCommand
32
Cause of the fault
Fault remedy
Frequency converter fault
Check frequency converter
Differential pressure fine
precipitator too high
Set differential pressure fine
precipitator
Fault of EA module (reports
a failure or does not
respond)
Check cabling/EA module
Dew point temperature too
Set dew point
Dew point temperature too
Set dew point
If a fault not listed in the fault table occurs, contact the
manufacturer immediately.
Warning/maintenance messages
: Warning/maintenance message
1 Warning symbol
2
Warning number
If an unexpected change to parameters occurs during operation, a
warning message and the warning symbol
appear on the display.
However, in comparison to the fault message, the compressor does
not switch off.
iCommand
- Basic
Personnel
person
Check frequency converter
Qualified
electrician
Set differential pressure fine
Manufacturer
Check cabling/EA module
Qualified
personnel
Qualified
personnel
Qualified
personnel
If a fault not listed in the fault table occurs, contact the
If an unexpected change to parameters occurs during operation, a
appear on the display.
However, in comparison to the fault message, the compressor does