iCommand-Touch Manual

CAP-837
2.8.3
Fault messages
A flashing tool symbol will appear in the left top of the basic display, if
a fault message is present. In addition a message pop
the bottom of the display the message in plain text . The message
window can be closed with the quit button. The
stays but only until the cause of the error has been corrected. The
compressor is switched
By pressing on the symbol in the title
be opened again.
Fault message Remarks
E065: Power fail
The power supply has failed (only if there is no "Aut
matic restart" function is programmed).
E066: Final temp. sen-
sor
Final compressor temperature outside measuring
range. Sensor defective or cable break.
E067: Oil temperature
sensor
Oil temperature measured values outside measuring
range. Sensor defective or cable break.
E068: Pressure sensor
Pressure measured values outside measuring range.
Sensor defective or cable break.
E070: Dew point sen-
sor
Dew point temperature
Sensor defective or cable break.
E071: Emergency stop
The Emergency OFF button was actuated.
E072:
Rotation direction
Direction of rotation incorrect
E073:
Motor temperature
Motor temperature monitoring input w
1 s.
E074: Overcurrent
Current monitoring input open. Delay 500 ms.
E075: Over pressure
Motor temperature monitoring input open. Delay 500
ms.
E076: Switch. cycles
exceeded
Only during active switch cycle monitoring.
E077:
Final temperature high
Compressor final temperature too high The temperature
has exceeded the set maximum temperature.
iCommand
54
Fault messages
A flashing tool symbol will appear in the left top of the basic display, if
a fault message is present. In addition a message pop
-
up appears at
the bottom of the display the message in plain text . The message
window can be closed with the quit button. The
fault icon in the title
stays but only until the cause of the error has been corrected. The
compressor is switched
-off.
By pressing on the symbol in the title
psi
, the plain text message can
be opened again.
Compressor type
The power supply has failed (only if there is no "Aut
o-
matic restart" function is programmed).
All
Final compressor temperature outside measuring
range. Sensor defective or cable break.
All
Oil temperature measured values outside measuring
range. Sensor defective or cable break.
All
Pressure measured values outside measuring range.
Sensor defective or cable break.
All
Dew point temperature
outside of measuring range.
Sensor defective or cable break.
All
The Emergency OFF button was actuated.
All
Direction of rotation incorrect
All
Motor temperature monitoring input w
as opened. Delay
All
Current monitoring input open. Delay 500 ms.
All
Motor temperature monitoring input open. Delay 500
All
Only during active switch cycle monitoring.
All
Compressor final temperature too high The temperature
has exceeded the set maximum temperature.
All
iCommand – Touch
iCommand
- Touch
A flashing tool symbol will appear in the left top of the basic display, if
up appears at
the bottom of the display the message in plain text . The message
fault icon in the title
psi
stays but only until the cause of the error has been corrected. The
, the plain text message can
Compressor type