iCommand-Touch Manual

CAP-837
Parameter
Value setting/Initial setting/Remarks
significantly exceeded.
Setting range: Yes/No
Initial setting: No
Remote LLC
Specifies if the switching off for all the LLC masters
and connected slaves is possible via the ACP co
trolled compressor stage. Switching on or off is done
via a respectively programmed digital input: "Remote
basic load cycle"
Setting range: Yes/No
Initial setting: No
Start pressure
Specifies the (lower) threshold to switch
pressor.
Setting range: 51
psi
Initial setting: Start
-
menu)
Stop pressure
Specifies the (upper) threshold to switch
pressor.
Setting
range: (Switch
sible maximum pressure of the current compressor
type
Initial setting: Cut-
out pressure (from the "Control"
menu)
Switch-on at
Specifies from what calculated usage a control co
pressor is switched on. Only if the functionality is
activated by setting a value larger than 0% for the
"Shut-
down at" parameter.
Setting range: "Shut
Initial set
ting: 100 %
Switch-off at
Specifies from which usage a control compressor is
switched off, if at least one more compressor is in
operation. Setting of 0% deactivates this function.
Setting range: 0 %
Initial setting: 0 %
iCommand
46
Value setting/Initial setting/Remarks
Compressor
type
significantly exceeded.
Setting range: Yes/No
Specifies if the switching off for all the LLC masters
and connected slaves is possible via the ACP co
n-
trolled compressor stage. Switching on or off is done
via a respectively programmed digital input: "Remote
Setting range: Yes/No
All
Specifies the (lower) threshold to switch
-on a com-
psi
– (Stop pressure minus 1 psi)
-
up pressure (from the "Control"
All
Specifies the (upper) threshold to switch
-off a com-
range: (Switch
-on pressure + 1 psi) – permis-
sible maximum pressure of the current compressor
out pressure (from the "Control"
All
Specifies from what calculated usage a control co
m-
pressor is switched on. Only if the functionality is
activated by setting a value larger than 0% for the
down at" parameter.
Setting range: "Shut
-down at" - 100%
ting: 100 %
All
Specifies from which usage a control compressor is
switched off, if at least one more compressor is in
operation. Setting of 0% deactivates this function.
Setting range: 0 %
– "Switch-on at"
All
iCommand – Touch
iCommand
- Touch
State
Editable
Editable
Editable
Editable
Editable