iCommand-Touch Manual

CAP-837
2.7.5.3
"Compressor type" screen
Fig. 46: "Compressor type" screen
This menu
Parameter
Value setting/Initial setting/Remarks
Main type
Specifies the compressor family for further compressor
selection.
Compressor selec-
tion
Specifies the compressor.
parameter the type
-
initial setting.
Inverter
Specifies whether the motor is controlled via an inverter
or via a Star/Delta.
Setting range: Yes/No
Initial setting: No
Pressure band
selection
Specifies the maximum pressure of the compressor
Setting range: depending on compressor type
Initial setting: depending on compressor type
Max. air volume
Specifies the max. air volume of the compressor
Setting range: 0 –
2354
Initial setting: depending on compressor type
iCommand
42
"Compressor type" screen
This menu
shows the settings for the compressor type.
Value setting/Initial setting/Remarks
Compressor
type
Specifies the compressor family for further compressor
All
Specifies the compressor.
Caution! When changing this
-
specific parameters are set to their
All
Specifies whether the motor is controlled via an inverter
Setting range: Yes/No
All
Specifies the maximum pressure of the compressor
Setting range: depending on compressor type
Initial setting: depending on compressor type
All
Specifies the max. air volume of the compressor
2354
cu ft³
Initial setting: depending on compressor type
All
iCommand – Touch
iCommand
- Touch
State
Display
Display
Display
Display
Display