iCommand-Touch Manual

CAP-837
2.7.4.8 "Screensaver" screen
Fig. 38: "Screensaver" screen
In this menu the settings for the screensaver
Parameter
Value setting/Initial setting/Remarks
Screensaver
active
Specifies if the Screensaver function is active.
Should the screensaver be active, the screensaver
will be shown after the delay and dimmed to
ness screensaver". A touch to the screen on any
place will activate the screensaver. The basic display
is then always displayed.
Setting range: Yes/No
Initial setting: Yes
Screensaver de-
lay
Here it is specified after what time period
operation the screensaver becomes active, meaning
the display is dimmed to the "Brightness screensa
er" value and the screensaver is displayed.
Setting range: 0 –
60 min
Initial setting: 5 min
Brightness normal
Specifies the brigh
tion.
Setting range: 20
–
Initial setting: 80 %
Brightness
screensaver
Specifies the brightness of the display when the
screensaver is active.
Setting range: 0 –
100 %
Initial setting: 50 %
iCommand
36
In this menu the settings for the screensaver
can be performed.
Value setting/Initial setting/Remarks
Compressor
type
Specifies if the Screensaver function is active.
Should the screensaver be active, the screensaver
will be shown after the delay and dimmed to
"Bright-
ness screensaver". A touch to the screen on any
place will activate the screensaver. The basic display
is then always displayed.
Setting range: Yes/No
All
Here it is specified after what time period
and without
operation the screensaver becomes active, meaning
the display is dimmed to the "Brightness screensa
v-
er" value and the screensaver is displayed.
60 min
Initial setting: 5 min
All
Specifies the brigh
tness of the display during opera-
–
100 %
Initial setting: 80 %
All
Specifies the brightness of the display when the
screensaver is active.
100 %
Initial setting: 50 %
All
iCommand – Touch
iCommand
- Touch
can be performed.
Compressor
State
Editable
Editable
Editable
Editable