iCommand-Touch Manual

CAP-837
2.7.4
"Timer" menu
Overview
Fig. 24: "Timer" screen

Date/Time (

Switching times compr. (
compr." screen

Pressure times compr.
compr." screen

Switching times outputs
outputs" screen
2.7.4.1 Date/Time screen
Fig. 25: Date/Time screen
This menu is used to set time and date. The weekday for the date is
automatically calculated. In addition, it is also possible to activate the
automatic daylight saving time. This takes into account the conversion
rules for the CET (Central European Time)
2.7.4.2
"Switching times compr." screen
In this menu, the start and stop of the compressor can be defined.
Fig. 26: "Switching times compr." screen
(start page)
The timer can be activated and deactivated. The compressor is only
released for the programmed times, if the "Switching times compr." is
set to "On". There are 8 Switching times (Channel 1
programming. These channels are connected with a
meaning the compressor can operate, if at least one channel permits
this.
Any timely limitations are cancelled, if the "Switching times compr." is
set to "Off". It is also possible to switch individual channels on or off.
The timer will n
channel is set to "Inactive". The set time however stay and can be
activated if needed.
iCommand
30
"Timer" menu
Date/Time (
 Chapter 2.7.4.1 ‘Date/Time screen
’ on page
Switching times compr. (
 Chapter 2.7.4.2 ‘
"Switching times
compr." screen
’ on page 36)
Pressure times compr.
( Chapter 2.7.4.3 ‘
"Pressure times
compr." screen
’ on page 37)
Switching times outputs
( Chapter 2.7.4.4 ‘
"Switching times
outputs" screen
’ on page 38)
This menu is used to set time and date. The weekday for the date is
automatically calculated. In addition, it is also possible to activate the
automatic daylight saving time. This takes into account the conversion
rules for the CET (Central European Time)
.
"Switching times compr." screen
In this menu, the start and stop of the compressor can be defined.
The timer can be activated and deactivated. The compressor is only
released for the programmed times, if the "Switching times compr." is
set to "On". There are 8 Switching times (Channel 1
-
8) available for
programming. These channels are connected with a
wire connection,
meaning the compressor can operate, if at least one channel permits
this.
Any timely limitations are cancelled, if the "Switching times compr." is
set to "Off". It is also possible to switch individual channels on or off.
The timer will n
ot be considered during the analysis, if a programmed
channel is set to "Inactive". The set time however stay and can be
activated if needed.
iCommand – Touch
iCommand
- Touch
’ on page
36)
"Switching times
"Pressure times
"Switching times
This menu is used to set time and date. The weekday for the date is
automatically calculated. In addition, it is also possible to activate the
automatic daylight saving time. This takes into account the conversion
In this menu, the start and stop of the compressor can be defined.
The timer can be activated and deactivated. The compressor is only
released for the programmed times, if the "Switching times compr." is
8) available for
wire connection,
meaning the compressor can operate, if at least one channel permits
Any timely limitations are cancelled, if the "Switching times compr." is
set to "Off". It is also possible to switch individual channels on or off.
ot be considered during the analysis, if a programmed
channel is set to "Inactive". The set time however stay and can be