iCommand-Touch Manual

CAP-837
2.7.1
"Control" menu
Parameter
Value setting/Initial setting/Remarks
Start-up pressure
Lower limit for the pressure regulation.
Setting range:
Initial setting: depending on compressor
Cut-out pressure
Upper limit for the pressure regulation.
Setting range: depending on compressor type, however at
least 1 PSI
Initial setting: depending on compressor type
Start-up
pressure 2
Lower limit for the pressure control when switching to the s
cond pressure range.
Setting range:
Initial setting: depending on compressor type
Cut-out pressure
2
Upper limit for the pressure control when
cond pressure range.
Setting range: depending on compressor type, however at
least 1 PSI
Initial setting: depending on compressor type
Minimum pres-
sure
The "Minimum pressure warning" is triggered
sure during LLC operation (slave) falls below the minimum
pressure. As long as the warning is present or is not acknow
edged, the compressor switches to internal pressure control.
Setting range:
Initial sett
ing: 0 PSI
iCommand
25
"Control" menu
This menu contains the following parameter:
Value setting/Initial setting/Remarks
Lower limit for the pressure regulation.
Setting range:
51 PSI – Stop pressure minus 1 PSI
Initial setting: depending on compressor
type
Upper limit for the pressure regulation.
Setting range: depending on compressor type, however at
above the start-up pressure
Initial setting: depending on compressor type
Lower limit for the pressure control when switching to the s
e-
cond pressure range.
Setting range:
51 PSI – Stop pressure minus 1 PSI
Initial setting: depending on compressor type
Upper limit for the pressure control when
switching to the se-
cond pressure range.
Setting range: depending on compressor type, however at
above the start-up pressure
Initial setting: depending on compressor type
The "Minimum pressure warning" is triggered
when the pres-
sure during LLC operation (slave) falls below the minimum
pressure. As long as the warning is present or is not acknow
l-
edged, the compressor switches to internal pressure control.
Setting range:
51 PSI – Stop pressure minus 1 PSI
ing: 0 PSI
(no minimum pressure monitoring)
iCommand – Touch
iCommand
- Touch
Compressor
type
State
All Editable
All Editable
All Editable
All Editable
All (only dur-
ing LLC op-
eration)
Editable