iCommand Manual

CAP-836
2.7.10
Switch the pressure unit: Code 0090
iCommand
27
Switch the pressure unit: Code 0090
By entering the code 0090, the pressure unit can be switched.
1.
Press and hold for three seconds.

The code input menu
appears on the display.
2.
Press .

A 1 appears on the display.
3.
Press .
4.
Set the code 0090 with the keys.
5.
To confirm the selected code, press .

The submenu for setting the pressure unit appears on the
display.
6.
There are three values from which to choose:
- 0: bar
- 1: MPa
-
2: psi (pounds per square inch)
Set the desired value with the keys.
7.
To confirm the selected value, press .

The set value is saved and the code input menu appears on
the display again.
8.
Press
again to go back to the basic display.
Value Pressure
unit
Description
0 bar
All pressure displays will be in bar.
1 MPa
All pressure displays will be in
Megapascals.
2 psi
All pressure displays will be in psi
(pounds per square inch).
iCommand
- Basic
By entering the code 0090, the pressure unit can be switched.
appears on the display.
The submenu for setting the pressure unit appears on the
There are three values from which to choose:
2: psi (pounds per square inch)
The set value is saved and the code input menu appears on
again to go back to the basic display.
All pressure displays will be in bar.
All pressure displays will be in
All pressure displays will be in psi
(pounds per square inch).