iCommand Manual

CAP-836
iCommand
22
Value Setting Description
0
Automatic
restart OFF
If the automatic restart after power
failure is switched off, then after a power
failure, the fault "no AC" is displayed.
This fault must be acknowledged
manually by pressing the
Otherwise, the compressor will not
restart.
1
Automatic
restart ON
If the automatic restart after power
failure is switched on, the time set in the
"shutdown time" parameter must elapse.
If the compressor was operating before
the power failure, then after this time has
elapsed, it will start up again. Otherwise,
the compr
essor will then switch to STOP
mode.
iCommand
- Basic
If the automatic restart after power
failure is switched off, then after a power
failure, the fault "no AC" is displayed.
This fault must be acknowledged
manually by pressing the
key.
Otherwise, the compressor will not
If the automatic restart after power
failure is switched on, the time set in the
"shutdown time" parameter must elapse.
If the compressor was operating before
the power failure, then after this time has
elapsed, it will start up again. Otherwise,
essor will then switch to STOP