3000 Controller

1-12
Entering Filter Menu Mode
Left Display Right
Display
Action
DROP DROP
Press the filter button until FILTER MENU is displayed for three seconds
changing to Filter.
FILTER
Blank Press  to scroll to Clean and Filter, Dispose, Fill Vat from Bulk (Bulk only),
Boil Out (functions only when controller is OFF), or Exit. With the desired
choice displayed press . Follow the instructions below to navigate the
modes.
1.9.1 Filter
Left Display Right Display Action
FILTER
Blank
Press and hold  until FILTER is displayed (or LEFT /RIGHT on
split vats).
LEFT (Split vats only) RIGHT (Split vats only)
Press either button under side to filter.
FILTER
Blank
Press the  button.
Filter Now? Yes No
Press  (YES) to continue. A no answer bypasses filtration and
cooking continues.
FILTER PAN READY? CONFIRM
Ensure the filter pan is in place and clean. Press .
OPEN DRAIN VALVE
Blank
Open drain valve.
Draining
:40 sec. countdown
timer
None required. If the drain valve becomes clogged with food
particles, use the Fryer’s Friend (poker-like tool) to clear the
blockage.
DANGER
NEVER attempt to clear a clogged drain valve from the front of the valve! Hot oil will rush out
creating the potential for severe burns.
DO NOT hammer on the drain valve with the cleanout rod or other objects. Damage to the ball
inside will result in leaks and will void the Frymaster warranty.
Turn Filter On CONFIRM
Turn filter on and press .
Flushing
:30 sec. countdown
timer
None required.
CLOSE DRAIN VALVE
Blank
Close drain valve.
Filling
:45 sec. countdown
timer
None required.
Turn Filter Off WHEN
FULL
CONFIRM
Turn filter off and press .
OFF OFF
DANGER
The crumb tray in fryers equipped with a filter system must be emptied into a fireproof container at the
end of frying operations each day. Some food particles can spontaneously combust if left soaking in
certain shortening material.
WARNING
Do not bang fry baskets or other utensils on the fryer’s joiner strip. The strip is present to seal the joint
between the fry vessels. Banging fry baskets on the strip to dislodge shortening will distort the strip,
adversely affecting its fit. It is designed for a tight fit and should only be removed for cleaning.