User Manual

www.FrSky-rc.com
- 3 -
above 30 meters.
e) Walk away from the model while simultaneously operating the controls on the transmitter. Have an assistant stand to confirm that
all controls are completely and correctly operational. You should be able to walk ab. 30m from the receiver without losing control.
f) Press the “F/S Range” button again, the range check will be finished.
3.5 Safety range indicator
When the model controlled by V8 2.4GHz radio control system is close to the maximum distance of control, the response of the
model will slow down. It is the safety feature designed by FrSky. It means, the user should fly the model closer to the transmitter as soon,
as the reactions are getting slower.
3.6 Signal loss indicator
In some special circumstances, such as a strong interference, the signal can be lost.
When signal lost in a short period, the receiver continues to try to search for the transmitter, at the same time, keeps the last
command from transmitter, until a new command is received.
Failsafe: Our receivers support all the failsafe function for every channel. Just do it as bellow:
After the receiver has been bind, press briefly the “F/S Range” button of the receiver, the GREEN LED of the receiver will flash twice,
the failsafe is set up successfully.
If you do not need the failsafe function any more, just re-bind the receiver.
Attention: Controlling distance is affected by the environment too. Please test it in an open field away from any obstacles. The
controlling distance in the air is greater than on the ground. Our controlling range is based on a conservative ground test.
Hope you enjoy our 2.4GHz products which have been designed and produced using the highest quality control measures available.
If you have any questions please do not hesitate to contact us.
FCC Statement
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate
the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following
Measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.
FCC Radiation Exposure Statement
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. This equipment should be
installed and operated with minimum distance 20cm between the radiator & your body.
CE in which countries where the product may be used freely: Germany, UK, Italy, Spain, Belgium, Netherlands, Portugal, Greece,
Ireland, Denmark, Luxembourg, Austria, Finland, Sweden, Norway and Iceland.
France: except the channel 10 through 13, law prohibits the use of other channels.