User Manual

31/07/12 12:25 PM
Page 9 of 13http://www.rchacker.com/projects/turnigy-9x/frsky-dht-module-ins…n?tmpl=%2Fsystem%2Fapp%2Ftemplates%2Fprint%2F&showPrintDialog=1
Step Three: Decide what to do with the mode switch.
What you do with this is personal preference. For now I only have two way modules so I don't expect to be using this
switch very much at all. We could install it on the outside of the transmitter but imagine what would happen if you
accidentally hit this while in flight. Also note that unplugging it from the bind switch board is the same as having it in two
way mode. I left it plugged in, set on 2 way mode put some tape around it and tucked it in behind the bind switch. That
way if I do decide to fit it later all I need to do is drill a new hole.
Step 4: Fit the antennae.
Question is where? The logical choice is to put it in the antennae hole but I wanted to keep all the new components in
the front of the 9X to allow easy opening. So I put it just to the side of the usual place on the front part of the 9X. It also
leaves room to put a good old FM antennae in later on.