User Manual

http://projects.onomato.biz/projects/android-dash!
8!
I typically need to set offset to 0, and tune the factor until i get the desired result. E.g. Cell Voltage
to 4.17V at fully charged battery.
These numbers will also affect the Threshold values for the Internal FrSky alarms.
Set FrSky Alarms... - FrSky Tx Module settings
This page allows you to see and program the internal FrSky alarms.
Note! the Application can not read the current state of the RSSI alarms. These will
therefore always show the default FrSky settings
For each alarm, you can set if the alarm should trigger when the current value is "Lower than" or
"Greater than" the threshold. You can also set the alarmtype/volume of the alarm.
The threshold will show you the threshold in the proper unit if you have already set up the channel
in the Channel Configuration.