User Manual

The third shows again the physical switches on the left, and the states of the 32 custom (logic) switches on the

right.

The last view is a channel monitor showing the servo outputs for all 32 channels (+/- change page). If channel

names are defined on the SERVOS page, they will show up here instead of the numbers for convenience.

Telemetry view

A LONG press of the PAGE key from any of the main views brings up the telemetry views. The PAGE and +/-

keys will then cycle between the power status screen (voltage, current, power or A1/A2 if not set, cell voltages

from an FLVS-01 sensor if connected), the min/max and GPS coordinates screen, and if defined from one to

three customs screens that can hold up to 12 items each, configured in the telemetry setup menu.