User Manual
Each field can be one of the various available parameters, of course the corresponding sensors and/or hub
must be installed in the model:
● Tmr1,2: Both timers
● SWR: Transmitter antenna quality. Should always be below 51, or a popup warning will appear and an
audio alarm will sound to warn you to check the radio's antenna. The value itself is of little meaning.
● RSSI: Lowest of the RSSI values from the radio and receiver in D8 mode. In D16 mode, RSSI of the
receiver.
● A1,2: Analog ports on D receivers (only A1 available on X8R receivers, with receiver voltage)
● Alt: Barometric altitude sensor
● Rpm: Engine speed, number of blades is adjusted in the settings above
● Fuel: Fuel level
● T1,T2: Temperature sensors 1 and 2
● Spd, Dist, GAlt: GPS speed, distance from starting point and GPS altitude
● Cell: Lowest cell on FLVS-01
● Cels: Sum of all cells on FLVS-01
● Vfas: FAS-40/100 voltage measurement
● Curr: Current, source configured in the settings above (FAS or analog)
● Cnsp: mAh used totalizer (needs current source configured correctly)
● Powr: Power, voltage and current sources configured above
● AccX,Y,Z: Acceleration values from TAS-01
● Hdg: GPS heading
● Vspd: Vertical speed (either calculated by the radio or reported by the sensor, depending on the sensor
type chosen above)
● xxx+/xxx-: Min and max values of the available parameters
Templates
The templates are currently "starting points" for model setups. When selected with ENTER LONG they will
either add to or replace the current model's mixers and settings with the usual ones for the usage scenario they
correspond to (best used on a newly created model). These can be used to build upon or tweak to achieve the
desired result, or simply to get an idea of what's required for that model type.
23