User Manual

● Model name: Self-explanatory... Change letter with +/- keys, go to the next with ENTER SHORT, or
press ENTER LONG to capitalize the current letter before switching to the next.
● Model image: There you can select a 64x32px, 16-grayscale .bmp file located in the BMP folder of the
SD card as your model logo. To be able to preview the images in the folder, use the SD Browser.
● Timers: There are 2 fully programmable timers, that can count either up or down. If the value is set to
00:00 they will count up from 0, if not they will count down from the preset value. The trigger is set using
the field next to the timer value, ABS counts up all the time, THs runs whenever the throttle stick isn't at
idle, THt starts the timer the first time throttle is advanced, TH% counts up as a percentage of the full
stick range. Persistent, if ticked, means the value is stored in memory when the radio is powered off or
model is changed, and will be reloaded next time the model is used. Minute call will beep / say the time
every full minute, while countdown will also give announcements several more times during the last
minute.
● Extended limits allow setting servo movement limits up to 125% instead of 100%.
● Extended trims allows trims to cover the full stick range instead of +/-25%. Be careful when using this
option, as holding the trim tabs for too long might trim so much as to render your model unflyable. The
"Reset" item will reset all trims (for all flight modes).
● Trim step sets the precision of trim clicks. Exponential means very fine steps close to the trim center,
but larger ones the farther you get from center.
● Throttle reverse: Ensures correct operation of throttle-based timers and functions for people who like
having full throttle with the stick down.
● Throttle source defines what triggers the THx functions of the timers. It's common to set it to the throttle
channel instead of the stick, so that throttle cut or other modifiers are taken into account.
● Throttle trim: IC engine mode, where trim only affects the idle part of the throw without touching the full
throttle point.
● Throttle Warning: Will warn you if the throttle stick is not at idle when the radio is powered up or a model
is loaded.
● Switch warning: Defines whether the radio requests the switches to be in predefined positions on power
on/model change. To set them, arrange your switches the way you like, and press ENTER LONG.
● Center beep: Makes a beep when the selected control(s) pass the center point.
13