Specifications

Floor
Wall
All stainless full wall mounted shower seat, phenolic top, white finish.
Specifications:Specifications:Specifications:
Retractable shower seatRetractable shower seatRetractable shower seat
All stainless full wall mounted shower seat, phenolic top, white finish.
Compact flip up shower seat retracts out of way when not in use.
One piece phenolic top, 5/16” (8mm) thick. Unit frame is fabricated from 1” O.D. 18 gauge
brushed finish type 304 stainless steel. Welded construction, features full 360 degree welds on
all joints. Support and flanges are also stainless steel with brushed finish.
The shower seat will support a load of 450 lbs when properly installed.
The shower seat is only as strong as the anchors and wall to which it is attached and therefore
must be firmly secured in order to sustain the load(s) for which it is intended. We suggest
installation by a qualified trades person.
Mounting hole locations are for reference when providing in wall support. Final
holes should be drilled using shower seat as a template. Mounting screws provided.
Site Location:
Features:
Installation:
Load Capacity:
Description and specifications applicable on date issued. Frost reserves the right to make improvements or changes without notice. Cat. No. 972 -1E
Code 972:
Overall dimensions in inches, (cetimeters in brackets).
Code: 972
18
(45.7)
11-7/8 (30.1)
16
(40.6)
14-1/4
(36.2)
5-3/8
(13.7)
29-3/4 (75.6)
18 (45.7)
12-3/4 (32.4)
1-3/4 (4.4)
13-1/4 (33.6)
8-3/8
(21.3)
Safety Warning: All shower seats must be installed by qualified trades persons. Installers
must consult and comply with local building codes. Mounting hardware and other systems to
be determined by contractor and installer pending specific structure, design, and conditions. All
installations must be fully inspected and approved by property owners and maintenance
personnel prior to seat being put into use. Failure to comply to proper installation procedure
will void warranty and may result in malfunctioning or injury.