User's Guide

AP Pass-Around Microphone

Using

1. Wake or remove the microphone from the

charger, wait 10 seconds for the tone.

2. Press the mute button, be sure to press on the

lower section of the button. Note the mute button is

lit.

Mute button LED On – On and transmitting

Mute button LED Off – In sleep mode

NOTE: In order to conserve battery life, your

microphone will automatically go into Standby

Mode (off) after 10 minutes of silence. To wake the

mic, press the Mute button again.

3. Keep the top of the microphone approximately 3-

4 in. (7.5 – 10cm) from the mouth when using as a

hand-held microphone.

4. Do not block photo diodes.

5. To allow hands-free use, (for example, when

reading aloud and turning pages, attach the

lanyard. Adjust the lanyard to position the

microphone approximately 4-5in. (10-13cm) from

the mouth.

6. When the battery in your microphone gets low

(approximately ½ hour of use time left) the battery

indicator will flash red.

7. At the end of the day, charge your microphone.

Photo diodes

Mute button

Battery indicator