INDOOR CAMERA USER GUIDE
APP SETUP To complete the setup, you will need a mobile phone, a 2.4 GHz Wi-Fi connection, and the password for your home Wi-Fi network. To add the Indoor Camera to your system, follow the steps below: 1 1. Bring your camera near your router and connect the power adapter. Plug the adapter into an outlet that cannot be turned ON/OFF*. *You can move the Indoor Camera to its final location once the app setup is complete. 2 2 2. Wait 2-3 minutes for the LED to start flashing white. 3 3.
Extra Tips For App Setup • During the app setup, you will be asked to temporarily connect to a network name that resembles ADC-V515 (XX:XX:XX)*. *The X’s are indicative of the device’s unique MAC address and will vary. • The LED lights on the camera will change during installation. When the LED is solid green, it has successfully connected to the Wi-Fi network. • If firmware updates are available, the installation may take up to 15 minutes.
USAGE GUIDE After positioning the camera, you’re ready to use it! Access live video and saved clips, Two-Way Audio, and adjust the Video Analytics configuration right from the Frontpoint mobile app. LIVE AND SAVED VIDEO • Navigate to the “Video” section. A In the “Live” menu, tap the play button in the video A. window to view live video. B In the “Saved” menu, tap a video clip to review your B. recordings. TWO-WAY AUDIO • Open your camera’s live video window in full screen. 1 Tap the play button ( 1. ).
VIDEO ANALYTICS While Video Analytics rules are encouraged to be created during the initial setup, they can be set up or modified at any time. To create Video Analytics rules, follow the steps below: •1 Navigate to the “Video” section. 2 1. Tap the gear in the upper right corner ( 3 2. Select “Recording Rules”. 4 3. Tap “Add” in the top right corner. 5 4. Tap “Video Analytics” in the New Video Rule menu. 6 5. Follow the on-screen instructions to complete the setup. ).
LED REFERENCE GUIDE Mode Description LED Behavior Solid Green Internet Connection The camera is connected to Wi-Fi. No Internet Connection The camera is not connected to Wi-Fi. Solid Red Flashing Red Boot Up The camera is powering on. The camera is in Wi-Fi pairing mode. To enter this mode, press and hold the button on the back of the camera until the LED is flashing white. Flashing White Wi-Fi Pairing Factory Reset The camera is resetting to factory default.
TROUBLESHOOTING • If you are having issues connecting the camera to the system, power cycle the camera. Simply unplug the power jack from the camera and then plug it back in to restore power. • If issues persist, you will need to reset the camera to factory default, see page 6 for factory reset information. • To access our Knowledge Base for more information on setup, settings, and troubleshooting scan the code to the right.
