Installation Guide

ManualsBrandsFrontLine ManualsBuilding materials4Ever Frame 180 1-1/4 in. x 2 in. x 83-1/2 in. Woodgrain Primed Composite Brickmould Kit (3-Pieces)

COMPOSITE DOOR FRAME

INSTALLATION INSTRUCTIONS

Contents:

• 83” left side frame with weather seal

• 83” right side frame with weather seal

• 36” top frame with weather seal

Other Components Required:

• Composite Brickmould kit

• Interior casing kit

• Shims

• (6) #8 x1-5/8” screws to fasten frame together

• (10) #10 x3” screws to fasten frame to rough

opening

Tools Required

• Tape measure

• Safety glasses

• Power drill/driver

• Power chop saw or miter box

• Framing square

• Level

Installation Instructions

STEP 1: Measure the rough opening.

STEP 2: Trim the frame to t around the door slab

being used (about 1/8 in. gap) and also to t in the

rough opening (about 1/2 in. gap.) The thick part

on the bottom of the side frame is factory cut at 5

degrees to t most sills. The top of the side is notched

to t the top frame. Trim the bottoms to t the sill

being used and to t the height. Cut the top frame

1-1/2 in. smaller than the nal frame width needed

STEP 3: Screw each side frame to the top frame with

(3) #8 x 1-5/8 in. screws.

STEP 4: Set the frame assembly in the rough opening.

Shim the frame in place at 5 locations on each side

and 1 on the head. Ensure it is plumb, level and

square.

STEP 5: Fasten the frame to the rough opening with

#10 x 3 in. screws through the side frames and head

at each shim location underneath the weather seal.

STEP 6: Install the Composite Brickmould kit on the

exterior of the door frame.

STEP 7: Install interior trim on the interior of the door

frame.

www.frontlinebldg.com | sales@frontlinebldg.com | 920-393-1340

STEP 8: Install hinges and lock plates as needed for

the door being hung on the frame. Route the frame

to t the hinges and lock plates selected.

STEP 9: For primed and woodgrain composite

jambs, nish the surface of the frames within 15 days

of installation to prevent the factory primer from

breaking down. Woodgrain has a tan primer on it to

accept stain, clear coat, or paint.

STEP 10: Seal with high quality caulk: inside top

corners, bottom corners to sill, brickmould to siding,

and brickmould to frame.

Summary of content (1 pages)

PAGE 1
COMPOSITE DOOR FRAME INSTALLATION INSTRUCTIONS Contents: STEP 8: Install hinges and lock plates as needed for • • • STEP 9: For primed and woodgrain composite 83” left side frame with weather seal 83” right side frame with weather seal 36” top frame with weather seal Other Components Required: • Composite Brickmould kit • Interior casing kit • Shims • (6) #8 x1-5/8” screws to fasten frame together • (10) #10 x3” screws to fasten frame to rough opening the door being hung on the frame.