User Manual Model: LAP , LAQ 802.11ac Outdoor PoE Access Point Customer Project Name: LAP-1, LAP-2 LITE-ON Project Name: WP9331D1-FT24 (LAP, LAP with antenna type I.) WP9331D2-FT24 (LAQ, LAP with antenna type II.) Version: V1.1 This document contains confidential proprietary information and is property of LTC. The contents of this document should not be disclosed to unauthorized persons without the written consent of LTC.
1 Product Descriptions The LAP, LAQ is a 2-radio, dual band dual concurrent, 802.11ac wave 2 access point. It provides powerful WLAN supporting wireless speed up to 400Mbps on 2.4GHz and 867Mbps on 5GHz, one Ethernet port to connect to the backbone network, another one Ethernet port can be aggregated to connect to one computer through the cable. LAP, LAQ could be powered by 24VDC/48VDC PoE injector which is supplied by customer.
1x 10/100/1000 Base-TX MDI/MDIX RJ-45 port with PoE PD (to engage with passive PoE injector which is provided by customer.) 1x 10/100/1000 Base-TX MDI/MDIX RJ-45 port Ethernet Pin definitions : 1/2/3/6 for Data transmission 4/5 for postive power pin 7/8 for negative power pin Compliant with following standards: 1. IEEE 802.3/802.3u 2. Hardware based 10/100/1000, full/half, flow control auto negotiation 3. Full duplex IEEE 802.
802.11n 2.4GHz on board 802.11ac 5GHz on board 2 internal antennas – 2.4G 2 internal antennas – 5G IEEE 802.11a, IEEE 802.11b, IEEE 802.11g, IEEE 802.11n, IEEE 802.11ac compliant Data Rate: 802.11a: 6, 9, 12, 18, 24, 36, 48, 54 802.11g: 54, 48, 36, 24, 18, 12, 9 & 6 Mbps 802.11b: 11, 5.5, 2 & 1 Mbps 802.11n: 20 MHz BW: 130, 117, 104, 78, 52, 39, 26, 13Mbps 40 MHz BW: 270, 243, 216, 162, 108, 81, 54, 27 Mbps 802.
Target type-I antenna HPBW: 170(H) x 90 (V) (Simulated results: HPBW: 185(H) x 90(V) @2.4GHz, HPBW: 178(H) x 71(V) @5GHz) Target type-II antenna HPBW: 120(H) x 30 (V) (Simulated results: HPBW: 115(H) x 50(V) @2.4GHz, HPBW: 115(H) x 50(V) @5GHz) Peak Gain: > 5.0dBi Typical – 2.4G Peak Gain: > 5.0dBi Typical – 5G Note: The HPBW depend on the optimized EVT results. Impedance: 50 Ohm nominal Antenna efficiency - 2.4G: 50% Antenna efficiency - 5G: 60% V.S.W.R.: 2.0:1 Max Reset 1 x reset button 2.1.
2.2 Antenna Internal antenna (Type I antenna for LAP) 2 × 2.4GHz antennas, Target HPBW: 170 x 90 degree, peak gain > 5.0dBi (The simulated results at 2.4GHz band are HPBW 185 x 90 degrees, peak gain is about 5.5dBi. The final results depend on the test reaults on EVT/DVT samples.) 2 × 5GHz antennas, Target HPBW: 170 x 90 degree, peak gain > 5.0dBi (The simulated results at 5GHz band are HPBW 178 x 71 degrees, peak gain is about 6.5dBi.
2.
3.1.2 Mounting Kit a. (Standard Accessories) - Pole mount (mounting kit code: OP-2-N, details refer to ME drawing separately) The proposal only supports pole mounting. Standard accessories include two metal clamps. Pole mounting with two metal clamps [mounting kit code: OP-2-N] b. (Standard Accessories) - Wall mount (mounting kit code: OW-1-N, details refer to ME drawing separately) The proposal only supports wall mounting. Standard accessories include one bracket and its screws.
Extra brackets and screws [mounting kit code: PW-5-N] d. (Optional, to be quoted and packed separately) Pole mount & Wall mount with extra mounting brackets (mounting kit code: PW-4-N, details refer to ME drawing separately): With two extra mounting brackets and the screws, LAP, LAQ can be mounted on pole with the ability of tilt up from 0 to 60 degrees and tilt down from 0 to 50 degrees. The mount kit can support Φ22 ~ Φ50mm pole diameter.
3.2 Physical & Environment 3.2.1 Operation Temperature - Temp: -40° C to +65° C - Humidity: 5% ~ 95%R.H non-condensing 3.2.2 Storage Temperature - Temp: -40° C to +70° C - Humidity: 5% ~ 95% non-condensing 3.2.3 IP Grade: IP67 3.2.4 Wind resistance Sustained wind: 100MPH Wind gust: up to 165MPH 4 Package Contents Package Contents - One unit of LAP, - One screw kit for wall mounting & poll mounting (3.1.
- Surge protection: 4KV (Prestest at LITEON or 3rd party lab by following IEC61000-4-5 standard) Others - RoHS (self- announcement) WEEE (self- announcement) 12
Federal Communication Commission Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
