Instructions / Assembly

tab
rack
Swivel
Caster (6)
brake
lever
Caster
Bolt (10)
Spring Washer (9)
Caster Nut (7)
Flat Washer (8)
Handle
Bolt (4)
Handle
(3)
Page 3
Assembly Instructions
Read the ENTIRE IMPORTANT SAFETY INFORMATION section at the beginning of this document
including all text under subheadings therein before set up or use of this product.
1. Assemble on a flat, level, hard and smooth
surface capable of safely supporting
a fully loaded Workbench.
2. Attach Handle (3) to either side of
Workbench using four Handle Bolts (4).
3. Attach two Swivel Casters (6) to the same
end as Handle using eight Caster Bolts (10)
from the inside of the cabinet down, secured
with eight Flat Washers (8), eight Spring
Washers (9), and eight Caster Nuts (7).
4. Attach two Fixed Casters (5) to the opposite
end from Handle using eight Caster Bolts (10)
from the inside of the cabinet down, secured
with eight Flat Washers (8), eight Spring
Washers (9), and eight Caster Nuts (7).
5. Lock the Swivel Casters by
depressing the brake levers.
6. Install the four tabs on each Left Shelf (12)
into the racks on the left side and center of the
Cabinet to install them at the desired heights.
7. Install the four tabs on each Right Shelf (13)
into the racks on the right side and center of
the Cabinet to install them at the desired
heights.
Distributed by: XDD Products(USA),LLC
A
A
A
B
B
B
B
8.
Put 3 long inserting pieces(14/A) to the drawer
then fix 4 smaller inserting pieces(15/B) to
correctposition as picture showing