Installation Manual

WTLD002_REV_A01
© 2019 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE 2
2.1
2.2
2.3
Remove the cover plate located in the rear
left corner inside the vehicle on top of the
left rear fender.
Remove the studs. Using a 16mm socket and
hammer to tap them loose.
Remove the left rear wheel.
Remove the safety belt support bracket.
Under the fender you will see the fuel tank
breather pipe.
Unclip the breather pipe and push it behind
the rear plastic cover and remove the
breather pipe clips.
There is a fender support bracket that needs
to be modified. Using your grinder cut the
gusset section of the bracket as close to the
body as possible Using a hammer, form the
remaining part of the bracket so that in is
flush with the body of the vehicle.