Installation Manual

WTLD001_REV_A00
© 2019 FRONT RUNNER VEHICLE OUTFITTERS
3
FIT AND SECURE 2
2.1
2.2
2.3
Place the Filler Cap Bracket (Item 3) into
the rear left hand corner of the vehicle, with
the bent lip facing down and up against the
"Raised Box" section.
Mark the hole in the centre of the plate onto
the vehicle a drill a 53mm hole using a hole
saw and drill machine.
Press out the inner circle from the Filler Cap
Bracket (Item 3).
Remove the left rear wheel. In the wheel
arch you will see the fuel tank and breather
pipe.
Unclip the breather pipe and push it behind
the rear plastic cover. Remove the breather
pipe clips.
Remove the Fender Stabaliser Arm as shown
in 2.3. Loosen the Mud Flap Arm situated
under the exhaust pipe.
53mm
8mm
10mm
13mm
17mm