Installation Manual
6
Wrap a small amount of thread tape
around the thread of the remaining
Plastic Elbows (Item 2) and fasten them
to one end of each Adaptor (Item 15).
Secure the barbed ends of the Elbows to
the open ends of the Inlet and Outlet
Hoses using a 16-25mm Hose Clamp
(Item 3).
(
D
)
INSTALL Water Tank cont...
(
E
)
If you are fitting a vehicle specific Deck Set, refer to the last page of your Installation Guide received with
your Decks and fit the RIGHT Front Face to the Drawer System.
Assemble the Inlet and Outlet Hoses, two Adaptors, four Bonded Washers, two Ball Valves and two Male
Barbed Fittings (Items , 13, 14, 15, 16) to the Front Face as shown below. Remember to wrap a small
amount of thread tape around the thread of each Male Barbed Fitting and Ball Valve.
If you do not have the Front face fitted the Ball Valve can be assembled to the Adaptor without the use of
the Bonded Washers.
(
F
)
REV_A01