Installation Manual

4
Prepare FOR INSTALL
Connect the Filter to Tank Hose (Item 10)
between the Tank and Filter. Secure the
Hose on either end using two 16-25 mm
Hose Clamps (Item 3) as shown.
() D
Loosen and remove the eight bolts at the rear of the Drawer System as indicated by the arrows.
If the Drawer System has the Corner Wings fitted from a previous installation, you will need to loosen and
remove the Wings.
() E
() F
If you are fitting Wings and a Deck Set to
your Drawer System, secure the "side"
Corner Wing Assemblies and a D-ring (if
required - refer to the vehicle specific
Fitment Guide received with your Deck
Set) to the Drawer System using four M6
x 20 Hex Bolts, four M6 x 19 Flat Washers
and four Spring Washers supplied with
your vehicle specific Deck and Wing Set
as shown.
REV_A01