Installation Manual

Push Up To Open
10
8
9
7
13
12
11
TBRA016_REV_A01
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
6
SIDE MOUNTING WITH FOOT RAIL3
3.4
3.5
3.6
Place the Latch (Item 13) into the rack, lining
up the mounting hole in the Latch with the
Nyloc Nut inserted in diagram 2.3. Secure
the latch in position using the M8x20 Button
Head Bolt and M8 Flat Washer (Items 11 and
12).
Fasten Items 7,8,9 and 10 as shown.
Open the latch by pushing on the latch
release and slide the table into position.
Check that the table has no forward/back-
ward movement when the latch is closed. If
it does, loosen the Nyloc Nuts (Item 6) from
diagram 3.1 and adjust so that the table has
no movement in the slides when the latch is
closed.
A small padlock can be used through the
hole in the latch release should you wish to
lock the table.
5mm
4mm
10mm