Installation Manual

Slide nut down "U" Channel
6
4
1
5
3
Underside Shown
TBRA016_REV_A01
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
5
SIDE MOUNTING WITH FOOT RAIL 3
3.1
3.2
3.3
Insert three M8x16 Bolts (Item 3) into the
slat as shown through the machined slots.
Loosely secure the table slides (Item 1) to
the rack using the M8 Nyloc Nuts and M8x19
slat washers items 4 and 5 as shown.
Space the table slides 250mm away from the
edge of the rack as shown.
The table slides are slotted left to right to
enable adjustment. Space the two table
slides 750mm or 550mm apart and tighten
all the Nyloc nuts. place a M8 nut cap (Item
6) over each Nyloc nut.
Working on the side of the rack that the
table will exit, insert a M8 Nyloc Nut (Item 6)
dome side down into the T-Slot of the rack
through the gap in the corner as shown.
Slide the Nyloc Nut down the T-Slot and
center the nut between the two table slides.
750mm or 550mm
mm052
13mm