Installation Manual

4th
2th
6
4
5
1
3
TBRA016_REV_A01
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
3
MOUNTING THE TABLE AT THE REAR OF THE RACK 2
2.1
2.2
2.3
Working underneath and from the rear of
the rack, slide two M8x16 Hex Bolts (Item 3)
into the second and fourth slats of the rack
through the machined slots. Loosely secure
the table slides (Item1) to the rack using
items 4 and 5 as shown.
Depending on the width of your table, space
the two table slides either 750mm or 550mm
apart. Tighten all the Nyloc Nuts and place
a M8 Nut Cap (Item 6) over each Nyloc Nut.
See diagram 2.1
Cut the T-slot Rubber (Item 2) to suite the
width of your rack and insert into the rear
T-slot of the first slat by pinching/squeezing
the sides of the rubber together and
pushing/rolling the rubber into the T-slot as
shown.
13mm
13mm
750mm or 550mm
Rear of Rack
(Shown Upside Down)
2