Installation Manual

3
POSITIONING THE BRACKETS
2
B)
To ensure your tent is centered. Grab
your measuring tape and measure the
width between the tracks (aluminum
extrusions) mounted to the bottom of
your tent. The aluminum tracks are
mounted to the brackets which in turn are
mounted to the roof rack.
C)
Measure the width of your roof rack. Using your
white marker, mark the roof rack slat at the
center point of the rack.
3
FASTENING THE TENT BRACKETS
D)
Divide the dimension measured in part 'B' by two. Subtract 25mm from this dimension, as this is
the offset from the outside of the track to the mounting center line. Measure this distance from
your marked center point from part 'C' either side of the mark, and make two more marks on the
slat. This is where you will position the brackets
A)
Depending on the position you are going to mount the tent, and the orientation of the tent
opening, will determine where and which slats will be used to attach the tent brackets.
Note: It is preferable to mount the tent brackets bridging two slats although it is possible to
mount it on one slat
A)
You now need to fasten the support brackets onto the markings which you made in step 2.
...CONT'D