Installation Manual

7
Install Drawer System cont...
REV_A03
Position the Corner Wing Assemblies from Step 2B over the corners of the Drawer as shown. Secure the
Assemblies to the Drawer using the remaining M6 x 20 Hex Bolts, M6 x 19 Flat Washers and M6 Spring
Washers. As in Step 3B, secure a D-Ring (Item 4) to each of the rear corners as shown.
(
C
)
Secure the Drawer System to the vehicle's tie down rings as
shown. For the rear mountings use two 60mm C- hooks and
a Turn Buckle (Items 2, 11). For the side mountings use one
115mm C-hook a Turn Buckle and one 60mm C-hook (Items
2, 32, 33). Ensure the Wing Nut, assembled to the Turn
Buckle in Step 2C, goes towards the top of the Drawer Sys-
tem. When tightening the Turn Buckles ensure that the
Drawer System remains centered left to right and 35 mm
from the front. Once the Drawer is secure in position tighten
the wing nuts on the Turn Buckles and the Bolts securing the
D-rings to the Drawer System.
()
D
SIDE MOUNTINGS
REAR MOUNTINGS
Ensure Wing
Nut at Top
Ensure Wing
Nut at Top