Installation Manual

8
Install Drawer System CONT...
Congratulations, you have completed your installation. Take a step back and admire your work. Good Job!
(
H
)
REV_A03
()
E
Fit the Side and Rear Decks (Items 28, 29, 30, 31) into position, by "clipping" the outer edge of the Decks
into the Wing Sliders (Items 24 & 26) and pushing the Decks towards the outside of the vehicle, thereby
adjusting the Slider to the correct length. Once you are happy with the length of the Slider, carefully re-
move the Decks taking care not to move the Sliders and fasten the two bolts on each Slider, locking it into
position.
Secure the center of the Rear Decks to the Rear Support (Item 23) using the two M6 x 25 Countersunk
Bolts and two M6 Finishing Washers (Items 34 & 35).
(
F
)
()
G
Assemble the two Front Faces (Items 36, 37) to the
side of the Drawer System using the four M6 x 16 But-
ton Head Bolts, four M6 Flat Washers and four Nyloc
Nuts (Items 38, 39, 40).