Installation Manual

3
Install drawer
Loosen the round end of the four Turn Buckles (Item 2). Screw a M6 Wing Nut (Item 3) onto each round
end and reassemble the Turn Buckle as shown.
() A
Assemble the M6 Eye Nuts and Nylon
Washers (Items 7 & 8) to the Stud Plates
(Item 9) as shown.
() B
REV_A00
() c
Assemble two D-rings (Item 4) to either side of the Drawer as shown using the M6 x 20 Hex Bolts, M6 x 19
Flat Washers and M6 Spring Washers as shown.