Installation Manual

8
Install Drawer System CONT...
Congratulations, you have completed your installation. Take a step back and admire your work. Good Job!
(
H
)
REV_A02
()
E
Fit the Side and Rear Decks (Items 28, 29, 30, 31) into position, by "clipping" the outer edge of the Decks
into the Sliders and pushing the Decks towards the outside of the vehicle, thereby adjusting the Slider to
the correct length. Once you are happy with the length of the Slider, carefully remove the Decks taking
care not to move the Sliders and fasten the two bolts on each Slider, locking it into position.
Secure the center of the Rear Decks to the Rear Support (Item 23) using the two M6 x 25 Countersunk
Bolts and two M6 Finishing Washers (Items 34 & 35).
( F )
()
G
Assemble the two Front Faces (Items 36, 37) to
the front of the Drawer System using the four
M6 x16 Button Head Bolts (Items 38) supplied.