Installation Manual

7
Install Drawer System cont...
REV_A02
Position the Rear Corner Assemblies from Step 2B over corners of the Draw as shown. Secure the Assem-
blies to the Drawer using four M6 x 20 Hex Bolts, four M6 x 19 Flat Washers and four M6 Spring Washers
(Items 20, 21, 22) received with SSWS001 and the remaining fasteners from Step 2E. As in Step 3B, secure
a D-Ring (Item 4) to each of the rear corners as shown.
(
C
)
Secure the Drawer System to the vehicle's tie down rings as
shown. For the rear mountings use two 60mm C- hooks and
a Turn Buckle (Items 2, 11). For the side mountings use one
115mm C-hook a Turn Buckle and one 60mm C-hook (Items
2, 32, 33). Ensure the Wing Nut goes towards the top of the
Drawer System. When tightening the Turn Buckles ensure
that the Drawer System remains centered left to right and 35
mm from the front. Once the Drawer is secure in position
tighten the wing nuts on the Turn Buckles and the Bolts se-
curing the D-rings to the Drawer System.
()
D
SIDE MOUNTINGS
REAR MOUNTINGS
Ensure Wing
Nut at Top
Ensure Wing
Nut at Top