Installation Manual

6
2
3
Place the Cargo Slider back into position lining up the four mounting points (Refer to Steps 2A & 2B). Flap
the two pieces of carpet from Step 2C over, so that the rear mounting feet are hard mounted against the
vehicle's body. Hand tighten the Slider into position using the M6 x 30 Button Head Bolts, M6 Spring
Washers and M6 x 19 x 1 Flat Washers (Items 3, 4, 5) supplied. Start with the front right corner next to the
speaker box as shown. Fasten the two rear mountings, working in an anti-clockwise direction. Remembe
r
not to open the Slider further than required when gaining access to the rear mounts as it may lift and
cause damage to your vehicle.
After the rear mountings are secure, open the Slider to gain access and fasten the front left mounting.
Once all four mountings are hand tight, close the Slider and push the whole assembly as far forward as
possible. Check that the tailgate closes without hitting the Slider. Go back and tighten all four mounting
bolts.
Should the Sliding Tray have any play, front to back, when in the closed position, please refer to Page 10
Step 4 on how to adjust the rubber stoppers.
Congratulations, you have completed your installation. Take a step back and admire your work. Good Job!
() D
Install The Cargo Slide cont...
1
Open the Slider slightly to gain access to the rear mounts. Do not open the slider more than is needed as it
will lift up and forward and could result in damage to the vehicle. Mark the outline of the left and right
rear mounting feet onto the carpet using a suitable marker. Move the Cargo Slide out of the way towards
the rear of the vehicle. Using a utility knife, cut three sides of the carpet allowing the carpet to create a
flap/hinge as shown.
(
C
)
REAR OF
VEHICLE
RIGHT HAND SIDE OF VEHICLE
LEFT HAND SIDE OF VEHICLE
REAR
SEATS
SSST003_REV_A01