Installation Manual

3
Remove the vehicle's jack and place it in the parcel
bin that runs from left to right at the rear of the
vehicle. Refit plastic trim.
GET ORGANIZED CONT...
()
B
()
C
Once your Cargo Slide has been removed from its packaging, turn the Cargo Slide upside down so that th
e
wooden base is facing upwards. Ensure this is done on a suitable surface as not to scratch your Cargo
Slide. Loosen and remove the wooden base by removing the three bolts as indicated by the arrows. The
three bolts and corresponding nuts may be discarded.
The wooden base may be kept and used as a "liner" for your Cargo Slide as shown below .
Loosen & Remove
Used as "Liner"
The front and rear Strapping Plates are shipped loosely fastened. Lift the Plates up until they hard stop
and secure in position by tightening the M6 Button Head Bolts as shown.
Parcel Bin
()
D
SSST003_REV_A01