Installation Manual

SSDS122_REV _A00
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
4
FIT AND SECURE 2
2.4
2.5
2.6
Fit the Front Side Wing (Item 5) to the
Drawer using M6 x 20 Hex Bolts, M6 SS
Spring Washers & M6 x 12 x 1 SS Flat
Washers (Items 9, 10 & 11) as shown.
Fit the Rear Side Wing, Rear Wing & Middle
Support (Items 6, 7 & 8) to the Drawer using
M6 x 20 Hex Bolts, M6 SS Spring Washers
and M6 x 12 x 1 SS Flat Washers (Items 9,
10 & 11) as shown.
Secure the Drawer to the Base Deck using
the Small Carabiners (Item 19) and the
turnbuckles supplied with the Drawer
(SSDR011).
Use the wing nuts on the turnbuckles to lock
them.
10mm
10mm
Place the Side Decks (Items 1LH & 1RH) on
Drawer to position the Drawer in the vehicle.
Ensure that the Side Decks follow the
contours of the panel inside the vehicle,
this will center the Drawer left to right and
back to front.
After the Drawer is in position, remove the
Side Decks.
5
9
10
11
9
10
11
8
76
19
19