Installation Manual

SSDS803_REV_A00
© COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS
4
2
3
9
10
14
15
17
16
FIT AND SECURE
2
13MM
13MM
Secure the drawer system to the vehicle
using the M8 x 70 Hex Bolts (Item 2),
M8x16x1.6SS Flat washer (Item 3),
large washer (Item 9) and M8 nyloc nut
(Item 10).
Refer to Figure 1.1
2.4
2.5
2.6
Using the holes in the mounting brackets
as guides, drill a 9mm hole through the
outer hole of each mounting bracket into
the vehicle's wheel arch.
TAKE NOTE If your vehicle has a removable
cover over the left rear wheel arch inside
the vehicle for access to the battery or
fuse box. The mounting bracket for this
point only requires fitment to the drawer
unit not to the vehicle. The remaining
3 mounting points are sufficient.
Fit the pinch weld (item 18) to both
face edges and then fit both outer
front faces with the fasteners shown.
8MM
3MM
9MM