Installation Manual

SSDR002_REV_A00
© 2020 FRONT RUNNER VEHICLE OUTFITTERS
3
D-Ring
D-Ring
FIT AND SECURE
2
2.1
2.2
2.3
Assemble each of the 4
turnbuckles (item 12) with a wing nut
(item 10) as shown. The wing nut will be
used to lock the turnbuckles after they
have been set.
Place the drawer in the vehicle
and position as desired. Making
sure the turnbuckles are pulling
outward to prevent the drawer
from moving after it has been secured.
Connect the C-hooks (item 6) onto the
D-rings on the drawers upright.
Connect the turnbuckles (item 7) on the
other side of the C-hooks and hook it into
the tie-down that are fitted to the
vehicle.
Secure the drawer by tensioning the
turnbuckles until there is no more
movement on the drawer. Make sure the
drawer stays in position when doing this.
Lock the turnbuckles with the wing nuts.
Do this by tightening the wing nuts up to
the turnbuckles.
Refer to diagram 2.1
10MM
5
7
6
6
7