Installation Manual

2
4
4
11
29
24
25
27
28
25
25
29
27
28
SSDS112_REV _A01
© 2019 FRONT RUNNER VEHICLE OUTFITTERS
7
FIT AND SECURE 2
2.10
2.11
2.12
RH Side
Before fitting the Side Wings you need to
relocate the cage nuts from the side of the
pillars to the inside faces of the pillars.
Looking at the right side of the drawer,
secure the Front RH Side Wing and the
Rear RH Side Wing (Items 24 & 25) using
M6x16 Hex Bolts, M6 Spring Washers and
M6x19x1SS Flat Washers(Items 27, 28 & 29)
as shown.
LH Side
Before fitting the Side Wings you need to
relocate the cage nuts from the side of the
pillars to the inside faces of the pillars.
Looking at the left side of the drawer, secure
the Front and Rear LH Side Wing (Item 26)
using M6x16 Hex Bolts, M6 Spring Washers
and M6x19x1SS Flat Washers(Items 27, 28 &
29) as shown.
Using the two Turnbuckles from
Step 2.1(Item 2) and the two 37mm
C-hooks (Item 11), secure the rear of the
Drawer System to the vehicle as shown.
Once the rear of the Drawer is secure,
tighten the Wing Nuts (Item 3).
3