Installation Manual

SSDS112_REV _A01
© 2019 FRONT RUNNER VEHICLE OUTFITTERS
6
FIT AND SECURE 2
2.7
2.8
2.9
Remove the cage nut shown. The Mounting
Plate (Item 17) will be secured through the
square hole where you have removed the
cage nuts.
Place the Mounting Plate (Item 17) into
position, lining up the two mounting holes in
the plate with the threaded mounting points
in the vehicle's body from Step 2.3. Secure
the plate to the vehicle using two M6x25
Hex Bolts, two M6 Spring Washers and two
M6x19x1SS Flat Washers (Items 13, 14 &
15). Place a M6 Nut Cap (Item 12) over each
Hex Bolt.
Place the Drawer System into the vehicle.
The front square holes in the base of the
Drawer sit over the studs in the Mounting
Plate as shown. Secure the Drawer to the
Mounting Plate using two M6 Nyloc Nuts
and two M6x19x1SS Flat Washers (Items 15
& 16). Place a M6 Nut Cap (Item 12) over
each of the Nyloc Nuts.