Installation Manual

5
7
6
5
7
6
29
27
28
4
23
22
21
4
SSDS112_REV _A01
© 2019 FRONT RUNNER VEHICLE OUTFITTERS
5
FIT AND SECURE
2
2.4
2.5
2.6
If the two original tie down rings (as
indicated by the arrows) have been removed
from the vehicle, they need to be refitted. If
the original tie down rings have been lost,
use two D-rings, two M6x20 Hex Bolts, two
M6x19x1ss Flat Washers and two M6 Spring
Washers (Items 4, 5, 6 & 7) supplied with
SSDR011.
Working at the rear of the drawer system,
remove the two top M6 Hex Bolts on both
the left and right hand side of the drawer.
Secure the Rear LH and RH Wings
(Items 21 & 23) together with two D-rings
(Item 4) as shown, using M6x20 Hex Bolts,
M6 Spring Washers and M6x19x1SS Flat
Washers (Items 5, 6 & 7).
Secure the Rear Center Wing (Item 22)
using M6x16 Hex Bolt, M6 Spring Washers
and M6x19x1SS Flat Washers
(Items 27, 28 & 29) as shown.
10MM
10MM
On certain models, it may be required to
relieve the corners of the plastic recesses
to allow the Mounting Plate (Item 17) to fit.