Installation Manual

9
Install Drawer System cont...
REV_A02
Secure the rear of the Drawer System to the D-rings fitted in Step 2H using a C- hook and Turn Buckle
(Items 2, 11) each side. Secure the side/ front mountings to the vehicle's tie down rings using the remain-
ing C-hooks and Turn Buckles. Ensure the Wing Nut goes towards the top of the Drawer System. When
tightening the Turn Buckles ensure that the Drawer System remains centered left to right and 20 mm from
the front. Once the Drawer is secure in position tighten the wing nuts on the Turn Buckles and the Bolts
securing the D-rings to the Drawer System and the vehicle's load bay .
()
D
REAR MOUNTINGS
Ensure Wing
Nut at Top
SIDE MOUNTINGS
Ensure Wing
Nut at Top
()
E
Fit the Side and Rear Decks (Items 28, 29, 30, 31) into position, by "clipping" the outer edge of the Decks
into the Wing Sliders (Items 24 & 26) and pushing the Decks towards the outside of the vehicle, thereby
adjusting the Slider to the correct length. Once you are happy with the length of the Slider, carefully re-
move the Decks taking care not to move the Sliders and fasten the two bolts on each Slider, locking it into
position.
Secure the center of the Rear Decks to the Rear Support (Item 23) using the two M6 x 25 Countersunk
Bolts and two M6 Finishing Washers (Items 38 & 39).
(
F
)
()
G
Assemble the two Front Faces (Items 40, 41) to
the front of the Drawer System using the four
M6 x 16 Button Head Bolts (Items 42) supplied.