Installation Manual

7
Prepare for installation cont...
REV_A02
Secure the two D-rings (Item 32 received with SSDS401) to the inside of the vehicle's load bay. You will be
bolting through the two 6.5 mm holes drilled in Step 2G using a two M6 x 25 Hex Bolts, four M6 x 19 Flat
Washers and a two M6 Nyloc Nuts (Items 33, 34, 35 received with SSDS401) as shown.
()
I
Install DrawER System
Lift the Drawer System (Item 1) into the vehicle's load bay and position it 20 mm in from the front of the
load bay and center it from left to right.
()
A
20 mm
Tail Gate