Installation Manual

8
Install Drawer System cont...
REV_A02
Position the Corner Wing Assemblies from Step 2B over the corners of the Drawer as shown. Secure the
Assemblies to the Drawer using the remaining M6 x 20 Hex Bolts, M6 x 19 Flat Washers and M6 Spring
Washers. As in Step 3B, secure a D-Ring (Item 4) to each of the rear corners as shown.
(
C
)
Secure the rear of the Drawer System to the D-rings fitted in Step 2H using a C- hook and Turn Buckle
(Items 2, 11) each side. Secure the side/ front mountings to the vehicle's tie down rings using the remain-
ing C-hooks and Turn Buckles. Ensure the Wing Nut, assembled to the Turn Buckle in Step 2C, goes to-
wards the top of the Drawer System. When tightening the Turn Buckles ensure that the Drawer System re-
mains centered left to right and 20 mm from the front. Once the Drawer is secure in position tighten the
wing nuts on the Turn Buckles and the Bolts securing the D-rings to the Drawer System and the vehicle's
load bay .
()
D
REAR MOUNTINGS
Ensure Wing
Nut at Top
SIDE MOUNTINGS
Ensure Wing
Nut at Top